Viconics SED-WMS-P (ZigBee Pro) Installation Guide - Manual (Page 3)

Motion Sensor Installation Guide
3
© 2
01
4 V
ic
on
ic
s. A
ll r
ig
ht
s r
es
er
ve
d.
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150
028-6078-00 www.viconics.com | [email protected] October 2014
INSTALL BATTERY
1. Using flathead screwdriver, gently pry cover away from Motion Sensor
(Figure 1).
2. Remove any packing tape from inside Motion Sensor.
3. Install one CR2 in Motion Sensor (Figure 2).
NOTE: ensure battery polarity is correct.
4. Verify sensing motion. Refer to "Verify Sensing Motion" on page 3.
VERIFY SENSING MOTION
1. Allow three minutes to pass for Motion Sensor to warm-up.
NOTE: Sensor requires a three minute warm-up time before it reports any
motion detection.
2. Wave hand or object over top area of Motion Sensor.
3. Verify LED flashes red on Motion Sensor (Figure 3).
NOTE: LED flashing red indicates motion detected.
4. Snap battery cover back in place.
5. Install Motion Sensor. Refer to "Install Motion Sensor" on page 4.
Figure - 1
Figure - 2
Figure 3
LED