Vexilar LPS-1 - Manual (Page 2)

Site Map • Contact Us • Privacy Statement • Terms of Use
©2012 Vexilar,
Inc.
Applications
Portable Uses - Turn unit on and touch the transducer end into water,
perpendicular to the bottom. Hold the switch forward until the unit locks
onto a reading. Release the switch and then raise the unit to read the
depth. If additional readings are desired - repeat procedure.
Scuba Diving - For your safety make certain that the LPS-1 is
operating correctly by testing in shallow water. For deeper diving
tighten snugly each end cap against its rubber seal. Watch the rubber
seals to make certain there are no bubbles escaping around the seals.
If a small stream of bubbles appear, tighten that particular end cap
more or until the stream of bubbles quit.
Ice Fishing - The LPS-1 will read through ice as long as it is fairly clear
and free from air bubbles, white ice. Clear away the snow and look for
clear hard ice then set the transducer end of the LPS-1 onto the ice.
Push the switch forward and, using some water, pour a small amount
directly onto the area where the LPS-1 contacts the ice. Hold the switch
forward until the unit locks onto a reading. If the conditions are not
right you may need to use more water and several readings should
taken to verify the proper depth. Note- Cold is very hard on batteries.
Make sure you keep the LPS-1 warm so when you need it, it will be
ready.
Home • Products • Accessories • Wear • Support • Pro-Staff • Extras
Vexilar LPS-1 Handheld Sonar Instructions http://vexilar.com/pages/support/instructions/instructions_lps-1.php
2 of 2 9/28/12 4:47 PM