VACUUBRAND MV 10C NT VARIO - Manual (Page 44)

page 44 of 145
Plug in the power cord.
• Check the power source and the pump’s
rating plate to be sure that the power source
and the equipment match in voltage, phase,
and frequency.
Switch the pump on.
O ➨ I
Switch the CVC 3000 controller on.
O ➨ I
VACUU•BUS
The VACUUBRAND controller CVC 3000 can only be operated with com-
ponents compatible with the VACUUBRAND VACUU•BUS system, (see
“Accessories / Spare parts”, pg. 92).
The vacuum controller CVC 3000 controls VACUUBRAND diaphragm
pumps NT VARIO and optional coolant and venting valves. Connected
components (e.g., venting valve, external pressure transducer 3000 se-
ries) are automatically identified and configurated. Identical components
must be configurated beforehand; information upon request.
Do not use more than one controller within the same VACUU•BUS
system.
Several controllers in the same VACUU•BUS system will interfere
with each other and result in error messages of the connected com-
ponents (pumps, valves).