Thermistor for cube control, Fig. 10 – Twin Eagles AM-50BAE-AD User Manual
Page 48

48
U1VA6060209
10. Thermistor for Cube Control
1) Unplug the icemaker or disconnect the power source.
2) Remove the top and front panels, door, louver, pipe cover (rear) and control box cover.
3) Remove the connectors on the controller board, referring to “9. Controller Board.”
4) Unscrew and remove the thermistor holder and thermistor, located on the evaporator.
5) Install the new thermistor in the reverse order of the removal procedure, by using a sealant
(high-thermal conductive type). See Fig. 10.
Note: Recommended sealant is KE4560RTV, manufactured by Shinetsu Silicon. When
other type of sealant used, the cube size and performance will be changed. Do
not use silicone sealant as this will insulate the thermistor.
Fig. 10
Sealant
Sealant
Holder
Holder
Holder
Evaporator
Screw
* Leads
* Thermistor
* Thermistor and Leads are FRAGILE.
HANDLE WITH CARE.