Iii. installation and operating instructions, Checks before installation, Location – Twin Eagles AM-50BAE-AD User Manual
Page 11: Checks before installation 2. location

11
U1VA6060209
III. Installation and Operating Instructions
1. Checks Before Installation
* Visually inspect the exterior of the shipping container and report any severe damage to
the carrier.
WARNING
Remove shipping tape(s) and packing as follows. If any are left in the
icemaker, it will not work properly.
IMPORTANT
1. Remove shipping tape holding the door.
2. Ensure all components, fasteners and thumbscrews are securely in place.
* Remove the package containing accessories. Remove shipping tape holding the separator.
* Check that refrigerant lines do not rub or touch lines or other surfaces.
* Check that the compressor is snug on all mounting pads.
* See the nameplate on the upper right part of the left side panel, and check that your voltage
supplied corresponds with the voltage specified on the nameplate.
2. Location
WARNING
Normal operating ambient temperature should be within 45°F (7°C) to 100°F
(38°C); Normal operating water temperature should be within 45°F (7°C) to
95°F (35°C). Operation of the icemaker, for extended periods, outside of
these normal temperature ranges may affect production capacity.
For best operating results:
* The icemaker should not be located next to ovens, grills or other high heat producing
equipment.
* The location should provide a firm foundation for the equipment. Level the icemaker from
side to side and front to rear.
* Avoid a site where dripping is not allowed.
* This icemaker will not work at subfreezing temperatures. To prevent damage to the water
supply line, drain the icemaker when air temperature is below freezing.
* This icemaker requires no clearance on either side. But allow enough space at rear for
water supply and drain connections and at least 15" (approx. 38 cm) clearance at front.