Triner Scale Axle Weighing Truck Scale 60,000 lb x 20 lb - Manual (Page 2)

Assembly Guide Axle Weighing Truck Scale
2
OVERVIEW
TOOLS REQUIRED
• Forklift and block
• Prybar
• Wrenches: #8 allen wrench, 15/16” & 30mm ratchet or pneumatic wrench
ESTIMATED TIME REQUIRED TO SET UP THE SYSTEM
• 10-12 hrs
RECOMMENDED NUMBER OF PERSONS TO SET UP THE SYSTEM
• Two
ASSEMBLY SYNOPSIS
Assembly of the scale is a very straightforward procedure. Most of the required assembly
time is in positioning the large, heavy platforms.
The platforms are labeled in sequence at each junction.
Once in place, the platforms are secured together with brackets. All brackets are labeled
to match up to the platform junctions.
The end ramps are secured to the platforms with a single bolt.
Each scale platform has a cable that runs directly to one of the three digital indicators. All
cables have quick connectors that are plainly labeled.
• The cables from the right side weighing platforms pass through the left side
platforms (at a junction) and then connect to the digital indicators.
• The cables from the left side weighing platforms run directly to the digital
indicators.
• The digital indicators display the weight of the steering axle, the drive axles,
and the trailer axles. The Trailer Axles Indicator displays three weights: Trailer
Axle Scale 1, Trailer Axle Scale 2, and the total weight of both Trailer Axle
Scales.
• The wireless remote displays are factory-interfaced and require no setup
(related digital indicator must be operating).