Trending Accessibility Transitional & modern linear fusion shower pan surface mounted on subfloor - Manual (Page 4)

Installation Guide
www.trendingaccessibility.com [email protected]
4
for linear shower pan surface mounted on subfloor
Step 5
For your dry run, position the Linear shower pan
into place and check to make sure the pan is level.
If you notice any rocking or flexing in the pan, you
may need to shim or shave areas.
Step 6
Important: You must sand the top of the pan lightly
with a palm or belt sander to roughen up the sur-
face for proper adhesion of waterproofing.
Step 7
To prep for permanent installation, remove the
Linear shower pan from the surface. Apply a
generous amount of construction adhesive to the
subfloor.
Step 8
Carefully set the Linear shower pan into place. Drill
and countersink holes in the Linear shower pan.
Using the 2 ½” screws provided, attach the pan.
Do not aggressively screw and over tighten, as you
may force the Linear pan out of level.