Installation guide, Step 12, Step 9 – Trending Accessibility Adjustable fusion shower pan surface mounted on concrete User Manual
Page 6: Step 10, Step 11
Installation Guide
www.trendingaccessibility.com
6
for adjustable fusion shower pan surface mounted on concrete
Step 9
To prep for permanent installation, remove the
Adjustable pan from the surface. Apply a generous
amount of construction adhesive to the concrete
floor. Place the pan down into position and apply
pressure to adhere the pan to the concrete.
Step 10
Again while insuring that your pan has remained
level, drill and counter sink holes into the
Adjustable Fusion Pan. Using cement anchors,
attach the pan. Do not aggressively screw and
over tighten, as you may force the pan out of level.
If required you may drill and
countersink anywhere on the
surface of the Adjustable
Fusion Pan.
You must use concrete achors
Step 12
Check that the Fusion Pan is level on all four sides.
Fill in any gaps around the perimeter of the pan over
1/8” with latex or acrylic caulk.
Do not use 100% silicone.
Step 11
Using a screed bed, bring the rest of the floor up to
the level of the Fusion pan.