Trending Accessibility Adjustable fusion shower pan surface mounted on concrete - Manual (Page 10)

Installation Guide
www.trendingaccessibility.com [email protected]
10
for adjustable fusion shower pan surface mounted on concrete
Step 25
The height adjustment ring and floor drain bowl
must now be fixed together using solvent cement.
Because solvent cements sets very rapidly we
strongly recommend the adjustment is done “dry”
first.
To set the permanent height of the grate frame,
place a floor tile beside the frame. Rotate the frame
until the height is about 1/16” higher (this accounts
for adhesive thickness). Now mark the position
of the adjustment ring. This mark shows the
final height position. Remove ring, apply solvent
cement, and re-align components to your marked
position. It is best to hold securely until pieces are
fully bonded.
Step 24
In order to set the correct height of the grate frame,
you may need to use the height extension ring
(see diagram to the right). If the height extension
ring is required, it will need to be fixed to the height
adjustment ring using solvent cement. The grate
frame can now be attached to the height adjustment
or extension ring, depending on tile thickness. This is
done by using firm pressure to clip the components
together; it is a tight fit.
“click”
extention ring
adjusting ring
1/4” to 5/8” Tile Height 5/8” - 1” Tile Height
grate frame
grate frame
adjusting ring
Step 26
You are now ready to tile. If you are using large
format tiles, they must be cut diagonally and laid to
follow the pitch in the Adjustable Fusion Pan (From
the corners of the grate frame to the corners of the
Fusion Pan). Apply the tile adhesive, and lay the
tiles in a regular pattern.