Trending Accessibility Adjustable fusion shower pan recessed into concrete - Manual (Page 4)

Installation Guide
www.trendingaccessibility.com [email protected]
4
for adjustable fusion shower pan recessed into concrete
Step 1
For optimal performance, it is imperative there
is a level surface prior to installation of a new
Fusion Pan. Check existing floor to make sure
it is level. If it is not, please correct prior to
installation. Place the pan in desired location
and mark the edge of the pan on the concrete.
Note: If the Adjustable Fusion Pan needs to be
trimmed, follow the guidlines on page 11.
Step 2
Using suitable equipment, and proper safety
gear, carefully cut along your line as accurately
as possible to a minimum depth of 1”. It may
be easiest to score the concrete approximately
every 1” to 2” inside your perimeter line, to make
the removal of the concrete more efficient. Now,
excavate all of the remaining concrete in the
marked area.
Note: If possible, please check or mark location
of existing plumbing and electrical to avoid
damaging them.
Step 3
Place the Fusion Pan into place. Once the pan
is set to the desired location, note the location
of drain and remove enough concrete for the
installation of the waste pipe, and drain body.
Step 4
Install the drain in accordance with current
plumbing and building codes.
Using a dust free saw makes the
work area more pleasant.
If you need to cut the
pan to fit into a cus-
tom location, please
refer to the cutting
and drilling guidline
on page 11 for de-
tailed directions