Toa C-CH210FH - Manual (Page 18)

18
Camera mounting bolt,
spring washer,
and plain washer
Camera mounting plate
Camera
Zoom lens
Camera mounting plate
mounting surface
Camera housing
Camera mounting bolt,
spring washer and plain washer
Sunshade
Zoom lens
mounting plate
Safety wire
Note
Do not remove the safety wire. If removed,
extreme force is applied to the joint of
camera housing and sunshade,
possibly causing damage to the housing.
Camera mounting plate attachment
and detachment (2 places)
Camera mounting
plate mounting surface
Butterfly bolt
Camera mounting
plate
Clamp plate
Note: Loosening the butterfly bolt allows
the clamp plate to move left and right.
Butterfly bolt
Camera mounting
plate
Zoom lens mounting plate adjustment
Zoom lens mounting plate
Note: Loosening the butterfly bolt allows
the zoom lens mounting plate to
move left and right.
9. CAMERA AND ZOOM LENS INSTALLATION
1. Remove the camera mounting plate from the camera housing. To remove, loosen two butterfly bolts and
pull them forward.
2. Mount the camera to the camera mounting plate, and the zoom lens to the zoom lens mounting plate using
the supplied nuts and bolts.
Note: The zoom lens mounting plate is supplied attached to the camera mounting plate.
[Bolts to be used]
• U1/4x10 camera mounting bolt ........................ 1 (accessory)
• U1/4 plain washer ............................................ 1 (accessory)
• U1/4 spring washer .......................................... 1 (accessory)
3. Perform wiring for the camera. (Refer to p. 10.)
4. Mount the camera and the zoom lens to the camera housing.
Place the camera mounting plate mounting surface between the camera mounting plate and the clamp
plate (2 places).
Push the two butterfly nuts away from you and retighten them to clamp the mounting surface.