Toa S5 Series Manual - Manual (Page 9)

S5 SERIES RACK MOUNT KIT
The rackmounting kit is supplied as standard with S5.5 systems, or is available as an
accessory for S5.3 systems.
19” Rack 2 x S5 series Receivers
1. Unscrew 3 x lid
retaining screws M3x6
from opposite sides of
each receiver case and
t angled brackets as
per illustration using
supplied screws.
2. Remove plastic
plugs from top of the
Receiver lid and place
metal joining strip in
lid slots and carefully
t M3x6 screws
(coloured black) as per
illustration.
3. Place remaining
joining strips x 2 on
the bottom side of the
receiver chassis using
M3x6 CSK screw as per
illustration.
19” rack 1 x S5 Series receiver with front mount antennae
4. Unscrew 3 x lid retaining screws M3x6 from
the left hand side of the chassis. (viewed
t angled bracket as per
illustration 1 using the supplied screws.
5. Unscrew 3 x lid retaining screw M3x6
from the right hand side of the chassis and
t supplied long bracket using the supplied
screws.
6. Fit extension cables as per illustration into
front panel long bracket and tighten BNC
nut. Should front mount antennae not be
t plastic blanking plug (supplied)
into spare holes.
POWER RF A
RF B uV 1 2 4 8 16 30 60 125 250 500
dB -36 -30 -24 -18 -12 -9 -3 0 +3 +6
POWER RF A
RF B uV 1 2 4 8 16 30 60 125 250 500
dB -36 -30 -24 -18 -12 -9 -3 0 +3 +6
8