Toa S5 Series Manual - Manual (Page 7)

TRANSMITTER SET-UP
BELTPACK
POWER
ON OFF
1. Insert battery into compartment by sliding end cap
forward and up. Ensure battery is inserted with the
correct polarity as shown.
2. Screw antenna into antenna socket as illustrated.
3. Plug Lavalier mic into Mini-XLR socket.
4. Place on-off switch to “On” position and observe
the display is on and the battery LED is illuminated.
Check display indicates same channel as receiver.
5. The receiver should now show received signal on its
RF bar graphs and after 20 seconds the transmitter
battery status.
6. Beltpack AF gain adjust. Turn on transmitter and
wait for the fl ashing “decimal point” on the LCD to
stop fl ashing. Press “Up” or “Down” buttons fi rmly to
increase or decrease AF gain with 10 steps with “0”
being minimum.
7. Frequency adjust
Turn on Transmitter and adjust frequency whilst
“decimal point” is fl ashing (approx 6 secs) via the
“Up” or “Down” buttons. When correct frequency is
selected turn transmitter “Off ” then “On” to activate
new selected channel.
Antenna
Lavalier mic Clip
Mini-XLR
Power LED
Antenna Bush
Power switch
Infra-red port
Up/Down
Battery indicator
Battery
compartment
LCD
6