Vermont Casting VC0620P - Manual (Page 22)

5. Push the plug into the connector until the
sleeve snaps forward to lock the fitting in
place. Turn on the shut-off valve. The flow of
gas to the appliance will be restricted if the
plug is not connected properly.
6. Test for gas leaks using an ammonia-free
soap and water solution.
1. Pull connector sleeve back and pull plug
out of socket. This will automatically shut off
gas to the appliance.
2. Close the shut-off valve and install the dust
caps on the socket and plug. Always turn off
the fuel supply at the shut-off valve when the
grill is not in use.
Test all the fuel supply connections using an
ammonia-free soap and water solution equally
mixed. Never use fire to test for leaks.
1. Turn on the gas shut-off valve.
2. Coat all connections of the fuel supply
system, especially at the quick-connect.
3. Watch for bubbles to indicate a leak.
4. If there is a leak, shut off the gas supply
and re-connect the hose to the socket. Re-test
for leaks.
Do not use the grill if a leak is detected that
cannot be corrected in this manner or if the
hose and connections become damaged.
Replace damaged components with only
factory authorized parts.
Do not strain or kink the fuel-supply hose.
See that the hose is kept clear of surfaces that
become hot during use.
TO DISCONNECT THE FUEL SUPPLY
LEAK TEST CONNECTIONS
OPERATING THE QUICK-CONNECT
Follow all directions on tags attached to hose.
1. To connect the fuel-supply hose to the fuel
supply, the shut-off valve must be closed.
2. Remove the dust cap from the connector
socket by sliding the connector sleeve back to
release the plug. Remove the dust cap from
the plug.
3. Position the plug end of the fuel supply
hose into the sleeve opening.
4. Slide the connector sleeve back, firmly
push the fitting into the connector.
22
Natural Gas Grills - Connecting to Natural Gas
Connector Sleeve
Dust Cap
Shut-off Valve
Plug
(for specially equipped natural gas grills only)