Toa ER-1000 WR - Manual (Page 9)

9
8.3. Fastening the Belt
Step 1. Adjust the length of the Belt.
The length of the Belt is adjusted on the
Buckle A side.
Note
To ensure a snug fit around the waist,
adjust the length when worn while the
belt is being stretched.
8.4. Unfastening the Belt
Step 1. Take a firm grip of both Buckle A and
Buckle B.
Hold both (of the Belt’s) buckles to
prevent the Main PA unit from dropping.
Step 2. Simultaneously press the upper and
lower Lock Levers on Buckle A.
Buckle A will unfasten from Buckle B.
Note
Tuck the extra part of the Belt into the
Belt Clip as shown in the figure on the
right, and it will not get in the way.
Step 2. Fasten the Main PA Unit around the waist.
Place the Main PA unit in the position it is going to be
worn, pull on the Belt and fasten Buckle A into Buckle B,
inserting it until it clicks into place.
Please confirm that the Lock Lever on
Buckle A is fully inserted into Buckle B.
Pulling on the long end of
the Belt will lengthen it.
Pulling on the end of the
Belt will shorten it.
Buckle A
Push here
Push here
Buckle A
Unfasten
Unfasten Buckle B
Lock Lever
Lock Lever
Buckle A
The clip can be moved
along the Belt.
Clip
Insert
Lock Lever
Lock Lever
Buckle A
Buckle B
Insert