Toa ER-1000 WR - Manual (Page 5)

5
Belt Clip
Secures the loose end of the belt after length adjustment.
Pouch
Holds a music player, standby batteries,
battery spacers, etc. Buckle A
Buckle B
Belt (with pouch)
An elastic one-touch buckle-type belt.
Attach snugly around the waist.
Refer to Belt Use on page 8.
Battery Cover
The battery compartment resides inside this cover.
Be sure to correctly open and close the cover.
Refer to Battery Replacement on page 6.
Microphone Plug
Insert this plug into the microphone
jack (MIC) located at the rear of the
Personal PA.
3.5 mm (1/8” ) mini-plug (monaural),
cable length: 1.3 m (4.27 ft)
Microphone jack
Microphone (with windscreen)
Position the microphone at the side of the mouth
so that it is not directly exposed to breath.
(Refer to the figure above.)
Hang over ear.
[Wearing the Headset Microphone]
Headband
(with Velcro)
Microphone Adjust length to
head size.
Approx. 3 cm
(1.18” )
Note
• Keep the microphone about 3 cm
(1.18” ) away from the mouth.
Voice output is distorted if too close
and becomes weak if too far away.
• Be sure to attach the windscreen
when using the microphone.
Failure to do so will result in wind
noise and allow perspiration or other
moisture to get into the microphone,
possibly resulting in malfunction.
Head Band
This band extends
around the back of
the head.
(See figure at right.)
[Personal PA – Underside]
[Headset Microphone (Accessory)]