Toa ER-1000 WR - Manual (Page 7)

7
Lock Lever
Battery Cover
Tabs
(1)
(2)
Step 3. Insert six AA-type batteries.
Notes
• Batteries are not all positioned facing the
same direction. Take note of the positive (+)
and negative (–) ends on the batteries and
insert them correctly in the directions
indicated.
• Ensure the batteries are firmly inserted into
the storage space. Trying to force the Battery
Cover into place when batteries are raised can
break the Battery Cover or make it difficult to
remove.
Step 4. Replace the Battery Cover.
Insert the tabs of the Battery Cover into the
Main PA Unit and then push the Lock Lever in
the direction indicated by the arrow.
Steps (1) and (2) must be carried out in order.
Note
Please confirm that the Battery Cover’s Lock
Lever is secured firmly in place.
7. USING THE BATTERY SPACER (ACCESSORY)
Inserting two supplied Battery Spacers allows the Personal PA to operate on four AA-type
batteries.
Insert the Battery Spacer in accordance with the battery polarity indicators, as shown in the
figure.
When using four batteries (using the Battery Spacers) instead of
six, ensure that all batteries used are new.
If old and new batteries are mixed, batteries may leak or explode,
possibly causing fire or injury.
CAUTION
Notes
• There is no designated place in which to insert the
Battery Spacer.
• Make sure the Battery Spacer’s positive (+) and
negative (–) indicators match the battery polarity
indicators on the main PA unit.
• A single Battery Spacer can be used (allowing the
system to be powered by five batteries).
• When operating on four AA-type batteries, volume
will not be as loud as when six batteries are used.
• When disposing of old batteries, take care that the
Battery Spacer is not also thrown away.
Battery Spacer
(2 included as accessories)