Toa 9000M2 Series Ver.200A - Manual (Page 3)

Page 3 of 33
1. SUMMARY
The RS-232C protocol described in this document is designed to be used to control the
9000M2 Series Amplifier from a PC and/or remote controller. This specification applies to
the 9000M2 Series firmware version 1.00 or later.
There are both descriptions of mixer mode and matrix mode in this manual, but only mixer
mode available with 9000M2 series.
Settings that can be controlled are as follows:
• Channel Fader Gain
• Crosspoint Gain
• Preset Memory Recall
• Channel ON/OFF
• Power ON/OFF
• Tone Control
• EQ Settings (ON/OFF, Band number selection, Gain setting, Q setting, Center frequency setting)
• Loudness Compensation Settings
• Filter Settings (High Pass Filter/Low Pass Filter)
• Filter Settings
• Input Sensitivity Setting
• Phantom Power ON/OFF Setting
• Paging Event Preset Recall
Following values can be read from the 9000M2 Series Amplifier.
• Channel name
When connecting the PC and/or remote controller to the 9000M2 Series Amplifier using this
protocol, set the 9000M2 Series Amplifier’s RS-232C port as follows:
Bit rate: 9,600/19,200/38,400/57,600 bps (Select the band rate depending on the
remote controller to be connected.) (See; Operating instructions of the
9000M2 Series Amplifiers.)
COMMANDLIST, COMMUNICATION EXAMPLES and PARAMETER TABLES are
available at the end of each section of this document.