Clarion HX-D2 - Manual (Page 20)

24
HX-D2
English
Setting the input level for portable
audio (AUX SENS)
This unit is provided with two AUX input lines.
The input level for third-party portable audio
connected to each of these lines can be set.
* The factory default setting is "MID".
1. Press the [ADJ] button.
2. Press the [ ] or [ ] button to select "AUX
SENS".
3. Press the [ s] button.
4. Press the [ ] or [ ] button to select the input
line.
Each press of the button switches the line as
follows:
AUX1 SENS: Input line 1
AUX2 SENS: Input line 2
5 Press the [ ] button.
6. Press the [ ] or [ ] button to select "HIGH",
"MID" or "LOW".
7. When you select this, press the [ ] button
to return to the screen in step 4.
8. Repeat steps 4 to 7 to set the input level of
each input line.
9. Press the [ADJ] button to return to the
previous mode.
Setting the digital output (D-OUT)
Set digital output ON when the digital output
connector is used as the digital output
connector of the built-in CD. There is no output
when "OFF" is set.
∗ This item cannot be set when a CD changer is
connected via the CeNET cable.
* The factory default setting is "OFF".
1. Press the [ADJ] button.
2. Press the [ ] or [ ] button to select "D-
OUT".
3. Press the [ ] or [ ] button to select "ON" or
"OFF".
4. Press the [ADJ] button to return to the
previous mode.
Setting the anti-theft indicator
(BLINK LED)
This function makes the indicator of Pch6 blink
(red) when ACC is OFF to create a visual anti-
theft effect.
* The factory default setting is "OFF".
1. Press the [ADJ] button.
2. Press the [ ] or [ ] button to select
"BLINK-LED".
3. Press the [ ] or [ ] button to select "ON" or
"OFF".
4. Press the [ADJ] button to return to the
previous mode.
Setting the beep tone during button
operation (BEEP)
A high-pitched beep tone is emitted when you
operate a button. This beep output can be
disabled.
* The factory default setting is "ON".
1. Press the [ADJ] button.
2. Press the [ ] or [ ] button to select
"BEEP".
3. Press the [ ] or [ ] button to select "ON" or
"OFF".
4. Press the [ADJ] button to return to the
previous mode.
Operations Common to Each Mode