Clarion HX-D2 - Manual (Page 15)

HX-D2
19
English
The following figure shows the factory default
settings for filter frequencies in the Multi mode.
The filter frequency ranges that can be set vary
according to the speaker. The following table
shows these ranges.
Note, however, that the frequencies are selected
from the value (1/3 octave steps) currently set
on this unit.
-: THROUGH (fixed) cannot be changed.
Operations Common to Each Mode
80Hz 500Hz 2kHz
Frequency band played back
mainly by SUB-W (to 80 kHz)
Frequency band played back
mainly by LOW (80 kHz to 500 Hz)
Frequency band played back mainly
by MID (500 Hz to 2 kHz)
Frequency band played back mainly
by HIGH (2 kHz onwards)
About filter slope (SLP)
Effectiveness can be adjusted for each filter
(HPF or LPF).
"-12dB/oct" is more effective than "-6dB/oct" and
"-18dB/oct" is much more effective.
The factory default setting is "-12dB/oct". Try
switching between "-6dB/oct", "-12dB/oct" and "-
18dB/oct " and select the setting that sounds
most natural to you.
●Characteristics during filter slope
adjustment
1oct
- 6dB
- 12dB
- 18dB
Gain(G)
Filter Frequency(fc)
1oct
-18dB
-12dB
-6dB
Speaker
FRONT
FRONT
REAR
SUB-W
HIGH
MID
LOW
SUB-W
HPF (lower limit
frequency)
315Hz to 20kHz
(factory default setting: 2kHz)
-
THROUGH, 25Hz to 250Hz
(factory default setting:THROUGH)
THROUGH, 16Hz to 80Hz
(factory default setting:THROUGH)
315Hz to 20kHz
(factory default setting: 2kHz)
THROUGH, 200Hz to 10kHz
(factory default setting: 500 Hz)
THROUGH, 25Hz to 250Hz
(factory default setting: 80Hz)
THROUGH, 16Hz to 80Hz
(factory default setting: THROUGH)
LPF (upper limit
frequency)
-
250Hz to 20kHz, THROUGH
(factory default setting: 2kHz)
-
25Hz to 250Hz, THROUGH
(factory default setting: 80Hz)
-
250Hz to 20kHz, THROUGH
(factory default setting: 2kHz)
250Hz to 10kHz, THROUGH
(factory default setting: 500 Hz)
25Hz to 250Hz, THROUGH
(factory default setting: 80Hz)
Standard
Multi