Toa CR-413-6 - Manual (Page 16)

16
Step 1. Attach the duct mounting plates to the appropriate position on the rear frames.
Step 2. Install the cable ducts to the duct mounting plates.
Screws used 4 x 10 tapping screw ..... 3 (per duct mounting plate)
Plain washer ................. 1 (per duct mounting plate)
Notes
• The duct mounting plate cannot be mounted at the place of the supporting runner. To mount, keep the duct
mounting plate a bit apart from the runner, and attach it to the rear frame.
• Installing the cable duct reduces the mountable depth of the component to be installed in a rack to 540 mm
(1.77 ft) from the panel mounting surface.
1
2
Rear frame
Rear
Duct mounting plate *
4 x 10 tapping screw *
4 x 10 tapping screw *
Cable duct *
Plain washer for M4 *
* Prepare separately.
Rear frame
Rear Cables
Cable tie (accessory)
4.7. Cable Binding
Bundle the cables of each component together using the supplied cable ties as shown below.