Toa CR-413-6 User Manual
Page 14
14
Step 2. Fit the supplied screw cover in the screw cover fittings.
Screw cover
(accessory)
Screw cover fitting attached to the component
(4 each on both sides)
4.5. 2202 Microphone Hanger (option) Installation
Install the optional 2202 Microphone Hanger to the rack's front frame to hang a handheld microphone.
Make holes in the desired position on the front frame referring to the figure below.
Note
Since no mounting screws are supplied with the microphone hanger, prepare two 4 x 10 tapping screws
separately.
12.6 (0.5)
2-ø3.2 (0.13)
[View with a microphone hung]
Microphone
Microphone hanger
[Mounting hole dimensional diagram
for the microphone hanger]
Unit: mm (inches)
See also other documents in the category Toa Equipment:
- D-2000 Series Installation (84 pages)
- DD-2000 Series Manual (24 pages)
- D-2000 Series Read Me First (12 pages)
- D-2012AS (2 pages)
- D-2012C (4 pages)
- D-901 (96 pages)
- CR-273 (20 pages)
- EV-20R (20 pages)
- MP-1216 (8 pages)
- MB-WT3 (2 pages)
- MT-251H (1 page)
- F-2322C (12 pages)
- F-2852C (12 pages)
- SC-630 (2 pages)
- ES-0851 (4 pages)
- ES-C0651 (4 pages)
- F-1000B (18 pages)
- F-122C (12 pages)
- F-122CU (20 pages)
- F-122CU2 (16 pages)
- F-1300B (18 pages)
- F-1522SC (8 pages)
- AN-9001 (1 page)
- C-AL80 (16 pages)
- DP-K1 (102 pages)
- DP-K1 (28 pages)
- DP-L2 v.2.00 (28 pages)
- DP-SP3 Protocol (14 pages)
- DP-SP3 (24 pages)
- DP-SP3 (75 pages)
- E-232 (8 pages)
- AT-063AP (4 pages)
- BS-1015BSB (8 pages)
- BS-1030B (4 pages)
- BS-634 (4 pages)
- BS-1034EN (8 pages)
- BS-1110W (4 pages)
- BS-301B (8 pages)
- BS-301B AS (4 pages)
- MB-WT1 (1 page)
- S-D7300 (16 pages)
- VX-200SP-2 (24 pages)
- YA-1000A (1 page)
- ZM-9001 (2 pages)