Toa FS-7000 SERIES Manual - Manual (Page 10)

10
5. Tone Controls
Adjust high and low frequencies of the output.
Frequencies are accentuated when the control is
rotated clockwise, and attenuated when rotated
counterclockwise. Controls are arranged from left
to right as follows:
• PRIORITY BASS
Adjusts the low frequencies of the Priority Output
on the rear panel.
• PRIORITY TREBLE
Adjusts the high frequencies of the Priority Output
on the rear panel.
• BGM BASS
Adjusts the low frequencies of the BGM Output on
the rear panel.
• BGM TREBLE
Adjusts the high frequencies of the BGM Output
on the rear panel.
6. Zone Indicators
Light to indicate current broadcast zones.
Note
These indicators also light during emergency
broadcasts when broadcast zones are selected by
signal inputs from an automatic fire alarm system.
7. Zone Selector Keys
Press these keys to select broadcast zones. To
cancel the selection, press the keys again.
Multiple broadcast zones can be selected
simultaneously with the additional use of the FS-
7000GM panel.
8. Busy Status Indicators
The indicator corresponding to the component
currently in use for broadcast lights while the
system is in general-purpose broadcast mode.
Note
These indicators do not light during emergency
broadcasts.
The priorities of the indicators are: TIMER,
PAGING, RM MIC, and CP IN-USE from high to
low. (Emergency broadcasts take precedence
over all other equipment operations.)
Each indicator is arranged from left to right as
follows:
• TIMER
Remains lit during broadcasts from the component
connected to the timer input.
• PAGING
Remains lit during broadcasts from the
component connected to the paging input.
• RM MIC
Remains lit during broadcasts from the FS-
7000RM.
• CP IN-USE
Remains lit during broadcasts from the FS-
7000CP. Announcements can be made via the
CP Microphone (2).
9. Speaker Line Short Indicator
Lights when 1 or more speaker lines connected
to the FS-7000JP have shorted.
(See page 30.)
10. All-Zone Call Indicator
Lights when the All-Zone Call button (13) is
pressed to select all broadcast zones
simultaneously. (Lights continuously only while
the FS-7000CP is operating or emergency
broadcasts are being made.)
11. Chime Button
Sounds a built-in 4-tone chime. This button can
be used only while the FS-7000CP is operating.
12. Reset Button
Resets the broadcast zones selected with the
Zone Selector keys (7) or All-Zone Call button
(13). Pressing this button also terminates
general-purpose broadcasts provided from the
FS-7000CP.
13. All-Zone Call Button
Selects all broadcast zones simultaneously.
14. Broadcast Zone Fill-In Space
Write the names of zones to be selected with the
Zone Selector keys (7) in this space.