ThermoWorks 226-270 DATA TEMPERATURE RECORDER - DTR Quick Start Guide - Manual (Page 8)

PAPER LOADING PROCEDURE
To reload the printer with a new paper roll, follow the steps below:
1.
Un-clip the printer cover handle (fig 1).
2. Pull the printer cover handle until the cover un-clips. To avoid
damage to the handle do not use excessive force (Fig 2).
3. Lift the lid until completely open (fig 3).
4. Remove any existing paper or the plastic tube from the previous
roll. The easiest way to do that is to turn the DTR upside down, so
the printer contents fall out (fig 4).
5. Prepare a new paper roll – remove the outer packaging and the
holding sticker. Place into printer as shown in Fig 5. The glossy
side of the paper should be against the printing mechanism
6. Push the paper fully into the printer housing (fig 6).
7. Close the lid, leaving a short strip of the paper roll protruding from
the printer (fig 7).
8. Lock the cover by pressing shut. Push the printer cover handle shut
(fig 8).
8