TeeJet FieldPilot Install John Deere 8xxx - Manual (Page 9)

www.teejet.com
7
FieldPilot ®
3. INSTALL STEERING SENSOR INTERFACES
The JD tractors have two steering sensors on the steering shaft in the cab. The connectors for these sensors
will need to be disconnected and Interfaces (K & L) will need to be installed. It does not matter which
interface, (K) or (L) , is connected to which connector. On some models the connectors are located on the
right side of the steering column. Other models have the connectors on the left side. Remove the necessary
panels from the steering column and disconnect the sensors. Install the appropriate dust cap from kit (P) on
one of the sensor connectors. The other steering sensor will be used in next step.
Figure 1-5: Install Steering Sensor Interfaces
install dust
Cap
Jd 8330
Jd 8225r Jd 8225r
K
l
steering sensor
Connection