TeeJet FieldPilot Install Case MX Magnum w/Factory Valve - Manual (Page 7)

www.teejet.com
7
FieldPilot ®
iNstAllAtioN
If there are questions concerning the installation of the FieldPilot system on this vehicle, or due to
the changes in component specifications the parts supplied in the kit are not exactly as presented
in this document, please contact your dealer or TeeJet Customer service representative for
clarification before installation. TeeJet Technologies is not responsible for misuse or incorrect installation of
the system.
NOTE: BE VERY CAREFUL TO ABSOLUTELY SECURE ALL CABLES AND HOSES SO THAT THEY
DON’T INTERFERE WITH THE MANY MOVING PARTS OF THE MACHINE!
1. RECOMMENDED ELECTRONICS INSTALLATION
The Steering Control Module (SCM) (I) should be mounted securely to the floor of the cab. Once the SCM is
securely mounted, connect it to harnesses (F&G) . Then connect interface (J) to harness (F) . The control
console can be mounted to the operator’s preference. The GPS antenna should be mounted as far forward
as possible on top of the cab on a metal surface of at least 4” square.
Figure 1-2: Recommended Electronics Installation
Gps