TeeJet FieldPilot Install Case IH 9150-9250-9330-9350 - Manual (Page 23)

www.teejet.com
21
FieldPilot ®
12. VeriFY OPeratiON OF hYdraUlicS aNd Set the SteeriNG
cONtrOl rate
Clean and pick up the area around the vehicle and make certain that it is safe to operate. Start the engine
and check hydraulic connections for leaks. Rotate the steering wheel from one extreme to the other and back
to center, check for leaks. While steering through the extremes of movement, check the cables and hoses for
wear points and strain, adjust as necessary.
The final oil flow rate adjustment is accomplished through the Matrix console. The
target lock to lock time is 8 seconds and the valve frequency is 175. Refer to the
Matrix manual for further instructions.
Use the Matrix console to perform the left to right steering test, counting the seconds to move the wheels
from full left to full right and also in the opposite direction. The vehicle should be moving forward very slowly
during these tests so there is not excessive side pressure on the tires. If you find that the machine steers in
the opposite direction from that being commanded in this steering test sequence, switch the valve connectors
at the FieldPilot valve
NOTE: To activate the manual overrides, a tool such as a small screwdriver or allen wrench must be inserted
into the end of the coil to depress the override button.
WARNING: PINCH POINT HAZARD! To prevent serious injury or death, avoid unsafe practice
while manually operating hydraulic steering circuits. Keep others away and stay clear of
mechanical steering linkages.
13. cOMPlete electrONic iNStallatiON
Refer to the owner’s manual supplied with the automated steering system to complete the electronic
installation and setup.