TeeJet FieldPilot Install Case IH 9150-9250-9330-9350 - Manual (Page 15)

www.teejet.com
13
FieldPilot ®
3. PrePare the OrBital
All of the hydraulic connections from the FieldPilot valve will be made at the orbital. First label all the hoses
on the orbital and then disconnect all 5 hoses. Install run tees (P) on the P and T ports. Install run tees (M)
on the R and L ports of the orbital. Install adapter (S) on to the LS port of the orbital.
Figure 1-6: Prepare the Orbital
4. iNStall the taNK aNd PreSSUre hOSeS
Connect hose (J) to the branch of run tee (P) as indicated and route it down and over to the T port of the
FieldPilot valve. Then connect hose (K) to the branch of run tee (P) and route it down and over to the P
port of the FieldPilot valve. Then reconnect the original pressure and tank hoses to the run of the appropriate
tee.
Access to orbital
l
p
s
p
pressure
tank
M
M
left
right
r
ls
ls