TechniSat DIGIT ISIO S - Manual (Page 39)

Fault Possible cause Solution
Receiver cannot be
operated, switched on or off
Defective data stream -->
receiver blocked
Hold down the On/Stand-
by button on the receiver
or the remote control for
approx. 5 seconds
Disconnect mains plug for
approx. 5 seconds, then
reconnect receiver
Perform Flash-Reset:
Warning!
All personal settings will be
lost
> Remove mains adapter
from the receiver
> Press and hold
Standby and the up
arrow key at the
same time
> Reinsert the mains
adapter while Standby
and the up arrow key
are pressed down
> Keep both buttons
pressed down for
approx. 5 sec. then
release. “Factory
setting” appears in the
display
USB device not recognised USB device formatted for
wrong file system
Format USB device in the
FAT32 file system
Device automatically
switches off after a certain
time
Auto Standby function
enabled
Check Auto Standby setting
and disable if necessary
39