TC-Helicon VoiceTone Double - Manual (Page 16)

17
Mono Sound Engineer Setup
If you are in a situation where a live sound engineer
mixes your vocal sound, you have the option of giving
them control over your mono wet/dry mix. In this
configuration the live sound engineer will receive one
channel with your dry vocal, and a fully wet effects
channel to mix in the mono doubling effects.
Configuring the Mono Sound Engineer Setup:
1. Connect your microphone to Double's Mic Input.
2. Connect the outputs to your sound system as
shown at right: Left and Right Outputs to two mic
inputs on your sound system. Set these channels’ pan
pots to center.
3. Hold the Bank Up and Patch 1 buttons while you
insert the connector from Double's power adapter into
the Power input.This action mutes the dry voice so that it’s
duplicated on both channels.
4. Confirm that stereo mode LED is off. If the Stereo
Light is on, press and hold Patch Buttons 2 and 3
simultaneously until the Stereo Light turns off.
Setup Configurations
This is a temporary power-up mode that must be
set each time it is used.
NOTE: