TC-Helicon VoiceTone Double - Manual (Page 23)

24
FAQ & Troubleshooting:
1. I'm not getting any sound out of Double
a. Confirm the power adapter is properly connected
by checking that a patch number is lit on the Numeric
Display.
b. Confirm your microphone is connected properly by
talking through microphone and looking for the Input
Light to light green or orange. If the Input Light is going
on, check your connections and settings on your sound
system. If the Input Light is not on, press the Right
Footswitch and turn the effect off, then try varying the
Input Knob and see if you can start to hear the
dry/unaffected signal through your sound system.
Additionally, if you have a condenser microphone,
ensure phantom power is enabled.
2. I'm not hearing any effect from Double, just
my dry voice
a. If you're running in stereo output mode, ensure the
Effect On Light is on. If it's off, press the Effect On button
once to engage it. Additionally, ensure the Mix Knob is
not in the off position (fully left).
b. If you're running in mono sound engineer mode,
confirm which outputs are connected to your sound
system. Only the Left Output will produce effects. If it's
not producing any effect sound, ensure the Effect On
Light is on. If it's off, press the Effect On button once to
engage it.
3. I don't hear any difference when I turn the
Pitch,Time, μMod or Overdub knobs.
a. Ensure the Effect On Light is on. If it's off, press the
Effect On button once to engage it.
b. Not all patches have all features enabled.Try rotating
the knob fully left, then fully right - then setting it to a
value.
5. My sound is distorted.
a. If your sound is only distorted when you have the
FAQ & Troubleshooting