TC-Helicon VoiceWorks Manual - Manual (Page 19)

17
VOICES & EFFECTS EDIT PARAMETERS
R EVERB T YPE
The list of reverb types includes the following
acoustic simulations:
Living Room, Chamber, Club, Classic Hall,
Concert Hall, Large Cathedral, Vocal Studio,
Vocal Room, Vocal Hall, Ambience, Live
Reverb, Plate1, Plate2, and Spring.
R EV P RE D LY T
Reverb Pre-delay time. Sets the delay time
prior to the reverb output. Large rooms
typically have reverbs that start much later
than the initial signal.
D ECAY
Reverb Decay Time.
L
Reverb Low Color. Specifies the characteristics
of the reverbs low frequencies.
H
Reverb High Color. Specifies the
characteristics of the reverbs high frequencies.
D ELAY T YPE
DualMono Delay- maintains the panning of the
sends.
PingPong1 sends the lead voice to the left
effect end only.
PingPong2 sends the lead voice to the sends
depending on the lead pan setting.
Left Delay Send
Right Delay Send
HF Damping Delay
HF Damping Delay
Feedback
Amount
Left Delay Out
Right Delay Out
Dual Mono Delay
PingPong1 and PingPong2 Delay
D LY (ms)
Using the DATA WHEEL, you can fine adjust
the current delay time.
D ELAY T EMPO S OURCE
TAP: the DLY time comes from the last tapped
tempo.
MCLK: the Dly time comes from incoming MIDI
clock messages.
IGNORE: the Dly time always comes from the
value manually entered into preset using the
DATA WHEEL.
D ELAY T EMPO R ATIO
Sets the ratio between the Tapped or MIDI
tempo and the resulting delay.
With TAP selected as a tempo source, the
tempo may be tapped in when any of the
three above parameters are selected.
FB
Delay feedback amount.
D
High Frequency Damping.
ay Send
ay Send
HF Damping Delay
HF Damping Delay
Feedback
Amount
Left Delay Out
Right Delay Out