TC-Helicon MP-76 - Reference Manual - Manual (Page 8)

Using MP-76 with your VoiceLive 3
MP-76 English Manual – 2015-01-20 6
Using MP-76 with
your VoiceLive 3
Make sure your VoiceLive 3 is running the newest
firmware version. Use VoiceSupport software to
update your device’s firmware. You can down-
load VoiceSupport here:
tc-helicon.com/products/voicesupport/
To enable Mic Control on VoiceLive 3 for your
MP-76:
► Press SETUP.
► Navigate to the INPUT tab using the < or >
arrow buttons.
► Select the INPUT TYPE parameter using the
Large Control Knob.
► Change the INPUT TYPE to MP-76 using the
far Right Mix Knob (below the screen).
To select what your MP-76 buttons do:
► Press SETUP.
► Navigate to the BUTTONMAP tab using the <
or > arrow buttons.
► Select the UP button parameter using the
Large Control Knob.
► Use the Mix knob below the parameter to se-
lect the “target” for the UP button.
(“Target” meaning: “what this button is sup-
posed to do/control.”)
► Set Mic Switch Mode to “Latched” or “Mo-
mentary”.
► “Latched” means:
“To activate the feature, press the button.
To deactivate the feature, press the button
again”.
► “Momentary” means:
“To activate the feature, press and hold
button. To deactivate the feature, release
the button”.
► Repeat this process for the other three mic
buttons (Left, Right, Down).
You’re done!