TC-Helicon MP-76 - Reference Manual - Manual (Page 10)

Using MP-76 with your VoiceSolo FX150
MP-76 English Manual – 2015-01-20 8
Using MP-76 with your
VoiceSolo FX150
Make sure your VoiceSolo FX150 is running
the newest firmware version. Use VoiceSupport
software to update your device’s firmware. You
can download VoiceSupport here:
tc-helicon.com/products/voicesupport/
► Ensure the +48V button on your VoiceSolo
FX150 is pressed IN.
► Press and HOLD the Low EQ button for the
channel you’ve got a Mic Control enabled mic
connected to for five seconds.
Please note that FX150 only supports MP-76
on Channel 2.
Mic Control for MP-76 is predefined:
► Up: Reverb on/off
► Left: Volume down
► Right: Volume up
► Bottom: Mute
MP-76 LCD and VoiceSolo FX150
On most supported products, the MP-76’s LCD
will show the preset number currently selected
on the device.
Since VoiceSolo FX150 has no presets, the dis-
play will shows the level of Channel 2 instead.
When Channel 2 is muted, the MP-76 display will
flash and show the level as “0”.