TC-Helicon VoiceLivePlay GTX Details manual - Manual (Page 17)

17
Setup - MIDI
MIDI Chan – sets the channel that the voiceLive play Gtx listens to for notes infor-
mation
make sure that your output/control (Keyboard, Computer etc ) device is set to the same channel as
the voiceLive play Gtx
CC Chan – sets the channel that the voiceLive play Gtx listens to for CC informa-
tion
make sure that your output device is set to the same channel as the Gtx
midi program Change and CC’s are as follows:
patch Change - General program Change
set Key - 30 (1e in hex)
set scale - 31 (1f in hex)
hit off/on - 28 (1C in hex) (0-63/64-127 for toggle)
taLK off/on - 114 (72 in hex) (0-63/64-127 for toggle)
Split Dir – Looks at the defined region of the keyboard for Notes information.
there are two settings:
1 above – notes played above the splitnote are registered for notes information
2 Below – notes played below the splitnote are registered for notes information
Filter – Ingores specific information, based on the setting.,
there are four settings:
1 none – all relevant midi data is processed
2 prgchange - ingores all program Change information, if it is recieved
3. Sysex - Ignores Sysex information. This can prevent unwanted firmware updates.
4 pC+sysex - ignores both sysex and program Change information
Transpose – transposes all incoming notes information
transposition is limited to four (4) octaves in either direction
Splitnote – sets the note at which split above/Below is registered