SUUNTO T6 - Manual (Page 40)

39
• Speed: Displays the speed in selected units (only if paired with a wireless speed
and distance sensor).
• Distance: Displays the distance from the beginning of the recording or lap (only if
paired with a wireless speed and distance sensor).
NOTE: If the altitude is not correct when the training starts, set it in the Alti/Baro
mode.
3.4.1. Stopwatch
With the stopwatch you can time your activities and record lap times. You can start
the stopwatch, stop it, and then restart it without having to reset it.
To use the stopwatch:
1. Press START/STOP to start the stopwatch.
2. Press UP/LAP to store lap/split times.
3. Press START/STOP to stop the stopwatch.
4. Long press UP/LAP to reset the stopwatch.
NOTE: When the stopwatch is on, the UP/LAP button is used for recording lap times
and the DOWN/LIGHT button switches between modes.
3.4.2. Connect
Connect is the first item in the Training menu. Press ENTER and choose Connect to
connect your Suunto t6 to the HR transmitter belt or a wireless speed and distance
sensor. Your Suunto t6 displays the message ‘
SEARCHING ’, while connecting to the
device. After this, the device informs you the device has been found. If the connection
fails, Suunto t6 displays the message ‘
NO DEVICES FOUND ’. Make sure the HR
transmitter belt fits snugly around your chest and the electrode area is wet or that the
wireless speed and distance sensor is switched on.