SUUNTO D6I User Manual

Page 51

WARNING

If there are several divers using a Suunto wireless transmitter,
always ensure that each diver is using a different code before
starting the dive.

In case there are several divers using the same code, the transmitter's code must be
changed before diving.
To assign a new transmitter code:
1.

Slowly open the cylinder valve fully to pressurize the system.

Immediately close the tank valve, and quickly depressurize the regulator so that
the pressure is reduced to less than 10 bar/145 psi. Wait about 10 seconds, and
slowly open the cylinder valve again to re-pressurize to above 15 bar/300 psi.
The transmitter assigns a new code automatically.

NOTE

To pair on the new transmitter code, the Suunto D6i code
must be cleared first.

To re-pair the transmitter with the new code and the Suunto D6i dive computer:
1.

In the DIVE mode of the Suunto D6i, long-press the DOWN button to enter the
DIVE settings. Enter the Tank Press Pairing menu (Refer to Section 5.8.3. Setting
the tank pressure pairing). Short-press the SELECT button to bypass the tank
pressure ON/OFF selection (the tank pressure transmission must remain ON).