Sunny Health & Fitness SF-E905 - Manual (Page 9)

9
EXERCISE COMPUTER MANUAL
No. 00196
FUNCTIONAL BUTTONS:
MODE – Press to select functions.
– Press and hold the MODE button for 6 seconds to reset time, distance and calories.
SET – Press to set values of time, pulse, distance and calories when not in scan mode.
A. Press the MODE button to cycle through functions: time, distance and calories to select desired
function.
B. Use the SET button to set a value for time, distance or calories. The value of a function will be set on
a countdown.
C. Press the MODE button once more, to save the function value you’ve created.
RESET – Press to reset time, pulse, distance and calories to zero when not in scan mode.
FUNCTIONS:
1. SCAN: Press MODE button until “▼” appears at SCAN position (or until “SCAN” appears), the computer
will rotate through all 5 functions: Time, Speed, Distance, Calories and Total Distance. Each display will
be held for 6 seconds.
2. TIME: Counts the total time of the exercise from start to finish.
3. SPEED: Displays the current speed.
4. DISTANCE (DIST): Counts the distance of an exercise from start to finish.
5. CALORIES (CAL): Counts the amount of total calories burned during an exercise from start to finish.
6. TOTAL DISTANCE (ODO): Counts the total distance after installing the batteries.
7. AUTO ON/OFF & AUTO START/STOP: If the wheel is put into motion, or any button is pressed the
computer will become active, and shall remain active while either of these two things continue to be
done, however without any signal for 4 minutes, the power (computer), will turn off automatically.
8. PULSE RATE (If Available)
Press MODE button until “▼” appears at PULSE position, (or until “ ” appears). In order properly
measure your pulse rate, you must place both your palms on the contact pads located on the handlebar
next to the seat, once you have done this the computer will show your current heart beat rate in beats
per minute (BPM) on the LCD after 3~4 seconds.
Remark: During the process of “pulse measurement”, as a result of the contact jamming, the
measurement value may be higher than virtual pulse rate during the first 2~3 seconds, after which it will
return to normal level. To ensure testing accuracy, it is suggested that user test pulse during stop/pause
exercise to avoid any possible influence. The measurement value cannot be regarded as the basis of
medical treatment.
9. ALARM
The functions of time, distance and calorie can be set to countdown, if any of the above value goes to
zero, the computer will alarm for 15 seconds.
Press MODE to select the function, then press SET to adjust the value.
Note:
● The computer containing only the “MODE” button does not have ALARM function.
● The computer can be programmed before delivery with Metric or Imperial system. If you find “M” in left
side of monitor screen, it’s an Imperial system and the unit will be expressed as mile.
SPECIFICATIONS
Auto Scan Every 6 seconds
Running Time 00:00 ~ 99:59 (Minute: Second)
Current Speed
The max pick-up signal is 999.9KM/H
or MILE/H (or 1500RPM)
Trip Distance 0.00 ~ 99.99 KM or MILE
Calories 0 ~ 999.9 Kcal
Total Distance 0 ~ 999.9 KM or MILE
FUNCTION
Pulse Rate 40-240BPM
Battery Type 2 pcs of SIZE-AA
Operating Temperature 0 ℃~ +40℃ (32℉~ 104℉)
Storage Temperature -10℃ ~ +60℃ (14℉~ 140℉)