Sunny Health & Fitness SF-E905 - Manual (Page 6)

6
Step 3: Install Pedal Support Tube and Swing Bar.
★IMPORTANT: Please read entire page before starting this step, and note all cautions.
A: Fix the Swing Bar (24L/R) to the long
axle of the Handlebar Post (9) with Hex
Bolt (25) and Flat Washer (26).
(Note: please don’t fasten tightly now)
B: Fix the Pedal Support Tube (18L/R)
to the Crank (49) with Locking Bolt
(19L/R), Wave Washer (61), then put on
Spring Washer (39) and Nylon Nut
(40L/R) to the end of Locking Bolt
(19L/R). IMPORTANT! Part 19 is
labeled L for LEFT and R for RIGHT.
Please make sure to turn 19L
counter-clockwise to tighten, and 19R
clockwise to tighten. Do not try to install the Left Bolt on the Right Crank or vice versa; the Left Bolt
is meant only for the Left Crank, same for the Right Bolt.
(The LEFT Nylon Nut (40L) is Silver, while the RIGHT Nylon Nut (40R) is Black)
(Note: Please don’t fasten tightly now)
The Right and Left Locking Bolt (No.19R/L) must fully penetrate the
nylon ring
of the Nylon Nut (40L/R) inside the Pedal Arm Joint and the
Crank. This will ensure the stability and durability of your Elliptical.
In order to install the Locking Bolt (19) properly, keep it perfectly straight
as the bolt goes through the pedal arms and into the crankshaft. If the
Locking Bolt is connected to the crankshaft at an angle, permanent
damage to both the bolt and the crank may occur.
If you experience any trouble with this step; please STOP and try the
alternate directions on the next page before continuing. Incorrect
installation can result in permanent damage to the item.
C: Fasten the Swing Bar (24L/R) and the Pedal Support Tube (18L/R) tightly with Hex Bolt (21), Flat
Washer (22), and Nylon Nut (23).
D: Fasten Hex Bolt (25) and Nylon Nut (40L/R) tightly now. Then cover the Nut Cap (20) (58) (57).
★ Ensure that ALL bolts and washers are in place and partially threaded in before completely tightening any
ONE bolt.