Sunny Health & Fitness SF-E905 - Manual (Page 8)

8
Step 5: Install the Handlebar and Armrest.
A: Fix the Armrest (31) onto the Handlebar Post (9)
using the Spring Washers (34) and Hex Bolts (35)
which came pre-attached to the Handlebar Post. Then
pull the Pulse Sensor Wire (46) through the small hole
on the front of the Handlebar Post (9) and pull them
out of the top (as seen in diagram below for Step 6).
Finally attach the Decorative Cover (36) onto the
Armrest (31).
B: Fix the Handlebar (32L/R) on the Swing Bar
(24L/R) with Carriage Bolt (37), Arc Washer (14)
and Domed Nut (33).
NOTE: If the Handlebar (32L/R) rubs the Armrest
(31) during the workout please check if you
assembled the correct parts to each side.
You should attach 32L to 24L (check the label on parts, Left is marked with an ‘L’).
You should attach 32R to 24R (check the label on parts, Right is marked with an ‘R’).
Step 6: Install the Meter.
Connect the Pulse Sensor Wires (46) and Upper Sensor Wire (15) to the
Meter (38) respectively. (NOTE: To avoid damaging the wires please
push them back into the Handlebar post before sliding the Meter on.)
Align the slot of the Handlebar post to the bulge inside the Meter (38) then
slide it onto the Handlebar Post (9) slowly.
INSTALLATION COMPLETE