Sunny Health & Fitness SF-E905 - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
Step 1: Install the Front Stabilizer & Rear Stabilizer.
Attach the Front Stabilizer (2) and Rear Stabilizer
(3) onto the Main Frame (1). Secure with the
Carriage Bolts (6), Arc Washers (7) and Domed
Nuts (8) which are pre-attached to the stabilizer.
★ Ensure that ALL bolts and washers are in
place and partially threaded in before
completely tightening any ONE bolt.
Step 2: Install the Tension Controller and the Handlebar Post.
A: Connect the Lower Sensor Wire (16) to the
Upper Sensor Wire (15), and then connect
Tension Hook (17) with Tension Cable (10b) as
shown in Picture A.
CAUTION :
Please make sure the Tension Controller (10a)
is set at resistance level 1 before you connect
the Tension Cable. This will ensure the wires are
at their longest reaching point. Also, having
someone else hold the Handlebar Post (9) will
make the connection easier when you connect
part (10b) to part (17). You may need them to
pull the post upward to stretch the cable.
(As seen in Diagram A; picture #3)
B: Insert the Handlebar Post (9) into the post of the Main Frame (1); secure in place with Allen Bolts (13)
and Arc Washers (14) which are pre-attached to the Main Section.
★
Ensure that ALL bolts and washers are in place and partially threaded in before completely tightening
any ONE bolt.