Sunny Health & Fitness SF-E905 - Manual (Page 11)

11
TROUBLE SHOOTING
1. If you find there is no difference between tension level 1 to level 8, please check the
connection of the tension cable. Please see Diagram A under Step 2.
2. If the meter does not show numbers correctly, please check the batteries. If the meter
does not count the speed and time, please check the connections of Upper Sensor
Wire (15) to the Meter (38) and Upper Sensor Wire (15) to Lower Sensor Wire (16).
3. If you have difficulty putting Part #19 into the Crank Arm (49), please try moving the
Crank Arm (49) to a different angle. *Keep in mind the Left Locking Bolt (19L) has
reversed threading and must be installed by turning counter-clockwise.
4. If you hear any noise when using the machine, please check if part #19, #21, #26 and
#52 are loose. You may remove these parts and add some lubricant oil to eliminate all
noise possibilities, remember to tighten all the parts securely.
5. When you first use the machine, if you hear any unusual noises from the inside of the
chain cover, please loosen the screws on the chain cover about two rotations, then
push the chain cover up a little bit; finally, fasten the screws you loosened before.
See the following diagram. (During shipping, the chain cover can be dislocated, and
the flywheel may rub on the chain cover.)