StarTech.com PM1115P2 Full - Manual (Page 6)

Instruction Manual
4
Reset Button
Reboot the Print Server:
1. Verify the power of print server is turned on.
2. Press the reset button once, and then release it.
Note: This will restart the print server and stop all on-going and pending print jobs.
Reset to Factory Defaults:
1. Disconnect the power adapter from the print server.
2. Hold down the reset button.
3. Reconnect the power adapter while continuing to hold the reset button for
about 5 seconds.
4. Release the reset button.
5. The print server will restart.
WARNING: This will erase all settings on the print server and return it to factory
default.
Note: A reset to factory defaults can also be performed through the web console,
covered later in this manual.
Default Settings
DHCP client: off
IP Address: 192.168.0.10
Subnet Mask: 255.255.255.0
Installation
Hardware Installation
1. Turn off the power to your printer.
2. Connect the print server to your printer with the appropriate printer cable.
3. Turn the printer on.
4. Plug in the AC power adapter into the DC jack on the print server.
5. Wait 10 seconds until the Status LED has stopped flashing.
6. Connect an RJ45 network cable to the print server, then to your network switch
or wall jack.