Cabletron Systems FOT-F3 - Manual (Page 7)

Page 1 - 2
INTRODUCTION
Chapter 2, Installation Requirements/Specifications,
contains a list of hardware, software, location and
environmental requirements that must be met before you
install the FOT-F3. A list of FOT-F3 specifications is also
provided.
Chapter 3, Installing the FOT-F3, contains steps for
unpacking the FOT-F3, setting the SQE switch,
connecting the transceiver to the network, connecting the
transceiver to an active Ethernet device, and, if desired,
mounting the transceiver with the Velcro
 mounts provided
with the unit.
Chapter 4, Testing and Troubleshooting, contains
procedures for verifying the proper installation of the
FOT-F3. It also describes LANVIEW
 LEDs and their
function.
You should have a general working knowledge of Ethernet
or IEEE 802.3 type data communications networks and
their physical layer components before installing the
FOT-F3.
1.2 GETTING HELP
If additional support is needed related to the Cabletron
Systems FOT-F3, or if you have any comments,
improvements, suggestions, or questions relating to this