Cabletron Systems FOT-F3 - Manual (Page 31)

Page 3 - 9
INSTALLATION
• Allows the AUI cable to be easily connected from the
transceiver to the workstation.
• Has a smooth, dirt-free surface which will easily
accept the adhesive bonds.
Mount the FOT-F3 as follows:
1. Separate the two 1.5" x 3" Velcro mounts.
2. Peel off the paper that covers the adhesive backing of
one Velcro mount.
3. Carefully position the Velcro on the back of the
FOT-F3. Be sure to press firmly so that the adhesive
firmly affixes.
4. Similarly, place the other half of Velcro on the surface
on which you want to mount the FOT-F3.
5. Attach the FOT-F3 to the Velcro mount.
3.4 CABLE SUPPORT INSTALLATION
Some attempt should be made to strain relief the cables
attached to the FOT-F3, whether or not the transceiver is
mounted.