Cabletron Systems FOT-F3 User Manual
Page 27
Page 3 - 5
INSTALLATION
If the PWR LED is not lit, perform the following steps:
a.
Verify that the power is turned on for the device
attached to the FOT-F3.
b.
Disconnect the AUI from the FOT-F3.
c.
Disconnect the device to which the transceiver is
attached.
d.
Check the AUI connections for proper pinouts.
The pinouts for the transceiver connection are
listed in Chapter 2.
e.
Check the cable for continuity.
f.
Reconnect the AUI cable to the FOT-F3 and
the device.
3.
Move the slide lock on the AUI connector to secure it
to the lock posts on the port.
3.2.3 Connecting the Fiber Optic Cable
This section describes how to connect the fiber optic link
segment to the FOT-F3. Perform the following steps only
after testing the fiber optic cable to ensure that the cable
has no defects.
- FOT-F3 (44 pages)
- BRIM-F6 (41 pages)
- WPIM-RT1 (50 pages)
- BRIM-WT1 (32 pages)
- 36 (33 pages)
- 9T101-04 (28 pages)
- FDDI Repeater (29 pages)
- SWPIM-BRI (34 pages)
- 9C114 (26 pages)
- SMARTSWITCH ROUTER 9032578-05 (398 pages)
- HSIM-W6 (258 pages)
- NB25 E (30 pages)
- HSIM-G01 (36 pages)
- HSIM-FE6 (42 pages)
- Expansion module 9E429-36 (18 pages)
- EMM-E6 Ethernet (205 pages)
- Environmental Module TM 9C300-1 (50 pages)
- CSMIM-T1 (198 pages)
- NBR-620 (73 pages)
- E2100 (42 pages)
- KBU64 Rackmount (26 pages)
- AirConnect 3Com (93 pages)
- 802.1Q (92 pages)
- W85 (60 pages)
- ELS10-26 (170 pages)
- Expansion module 9E106-06 (40 pages)
- 6H259-17 (58 pages)
- Expansion module 9F120-08 (12 pages)
- EMC39-12 (33 pages)
- 6A000/ZX-250 (268 pages)
- Expansion module DELHE-UA (50 pages)
- Expansion module 9T122-08 (36 pages)
- DMS-100 (196 pages)
- BRIM E100 BRIM-E100 (42 pages)
- Cabletron CyberSWITCH CSX400 (275 pages)
- Cabletron SmartSwitch Router 250 (34 pages)
- Network Router (100 pages)
- 9W111-08 (28 pages)
- CSX400 (101 pages)
- Cabletron SmartSwitch Router 510 (106 pages)
- SEHI-32/34 (90 pages)
- SmartSwitch (338 pages)
- 9T106-01 (28 pages)
- Switch 9H531-17 (38 pages)