StarTech.com SV431TDVIUA - Manual (Page 9)

Instruction Manual
6
Scan Time
Four options are available for users to set the Scan Time duration, it Includes 3, 8, 15
and 30 seconds.
Note: Scan Time is set to 3 seconds by default.
To adjust Scan Time, set the scan time of duration before switching to the next computer:
Left + Left +
The KVM Switch generates 1 to 4 beeps indicating a scan time duration for 3, 8, 15 or
30 seconds respectively.
Adjust Video Signal (for 4 port model only)
The video signal can be optimized to the length or quality of your DVI cable. Only
perform this operation if you are experiencing video quality issues.
Step 1. Press the “FUNC” button 3 times. The “POWER” LED will start flashing.
Step 2. The settings are adjusted by pressing the numbered buttons on the front of the KVM.
A) Button “1” Adjusts the EQUALIZATION of the video source. 1 Beep is normal, 2
beeps is enhanced.
B) Button “3” Adjusts the output CURRENT of the video source. 1 Beep is normal,
2 beeps is enhanced.
C) Button “4” Adjusts the AMPLIFICATION of the video source. 1 Beep is normal,
2 beeps is low, 3 beeps is medium, 4 beeps is high.
Step 3. Press the same “FUNC” button from Step 1 to exit.