StarTech.com SV431TDVIUA - Manual (Page 7)

Instruction Manual
4
8. Once operation has been successfully confirmed, switch to the next port and power
up that computer/device and confirm.
9. Once completed for all computers/devices connected to the KVM switch, you
should be able to switch between ports freely.
Driver Installation
No driver installation is required for the KVM switch, as the keyboard/mouse use USB
drivers that are already installed on any operating system that fully supports USB.
Operation
Front Panel
Port Selection/Link LED
The LED turns green when the connected computer is powered-on. The
corresponding LED will also illuminate red when that PC port is currently selected.
Port Selection Button
For 2 Port model, each push of the Selection Button on the front of the KVM switch
will immediately switch between the two ports on the KVM switch.
For 4 Port model, each push of the Selection Button on the front of the KVM switch
will immediately switch to the selected computer.
Auto Scan
The KVM automatically scans through the powered-on computers in sequence on
a fixed time interval (see Scan Time below). To activate Auto Scan, press down front
panel push buttons “3” and “4” simultaneously. The port LED flashes during Auto Scan.
Auto Scan is effective for powered-on computers only. To exit the Auto Scan mode, just
tap any one of the push buttons. (4 port model only)
NOTE: When Auto Scan detects any keyboard activity, it suspends the scanning until
the activity stops; it then resumes with the next computer in sequence. The length of
the Auto Scan interval (Scan Rate) is adjustable, see below.
Scan Time
Four options are available for users to set the Scan Time duration, which includes 3, 8,
15 and 30 seconds.
To change the Scan Time interval, press both front panel buttons “1” and “2”
simultaneously. The unit beeps 1, 2, 3 or 4 times for Scan Time of 3, 8, 15 or 30 seconds
respectively. (4 port model only)
NOTE: Scan Time is automatically set to the default of 3 seconds when the units loses power.