StarTech.com SV431DDVDUA - Manual (Page 9)

Instruction Manual
5
Rear Panel (SV431DDVDUA only)
To adjust the video signal strength/equalization settings for the length or quality of
DVI cable being used, the “FUNC” button combined with the front panel push buttons
can be used.
1. Press “FUNC” button three times, and the LED for “POWER” will start to flash once
per second.
2. Press front panel push button “1” one or two times to adjust the signal equalization
with one beep (normal) or two beeps (enhance) respectively.
or
Press front panel push button “3” one or two times to adjust the video signal output
current with one beep (normal) or two beeps (enhance) respectively.
or
Press front panel push button “4” one, two, three, or four times to adjust the output
emphasis with one beep (no pre-emphasis), two beeps (low pre-emphasis), three
beeps (medium pre-emphasis), or four beeps (high pre-emphasis).
3. Once the settings have been adjusted, press the “FUNC” button one time to exit
this mode.