Source Audio Soundblox 2 Dimension Reverb - Manual (Page 24)

24 | External Control
USE WITH HOT HAND
All Soundblox pedals are compatible with our Hot Hand accessories. Hot
Hand units consist of a ring mounted accelerometer that is used to detect
motion for controlling effect parameters. On the Dimension Reverb, a Hot
Hand unit can be connected to the Multi-Function input. To enable Hot
Hand, select the HH mode as the external control option. This will take
the input signals for the Hot Hand unit and use them to control whichever
parameter has been assigned.
The Dimension Reverb can also be calibrated to change the midpoint of
the Hot Hand control range. To do this, follow the calibration procedure
below. Note that calibration is only used for Hot Hand mode and calibra-
tion is NOT required before use.
To perform a calibration:
1. Select a preset by pressing a footswitch.
2. Enable Hot Hand control by selecting HH mode from the external
controls.
3. Press and hold the CONTROL INPUT button until the HH red LED be-
gins to blink slowly (this is the same as the control assign procedure).
4. Put the Hot Hand sensor into the desired calibration position.
5. Press the footswitch for the currently selected preset.
6. The HH LED will blink when the calibration is complete.
If you have trouble with calibration and need to get back to the default
setting, place the sensor on a flat, level surface with the blue LED facing
down and run the calibration procedure again.